TITAN
103
EN
cod. 3541Z410 - Rev 01 - 09/2022
- Parameters
Each system requires a different parameterization. Follow the access procedure given below.
“Configuration - Parameters Menu”
Check/Change parameter
b02
of the “Configuration - Parameters Menu” to
9
.
Check/Change parameter
b08
of the “Configuration - Parameters Menu” to
1
.
Check/Change parameter
b04, b05 and b06
of the "Configuration - Parameters Menu" according to the values given
in the table ”Configuration - Parameters Menu” on page 115 .
- Parameters FZ4B
See relevant manual in Kit.
- Optional features
In addition to the electrical connections of the previous figure (necessary for this system configuration) there are options
that do not require settings.
Legend (fig. 54)
301
Fault indication (voltage-free contact output): the
example shows the connection of a 230Vac
lamp
302
Remote reset input (230Vac): the example
shows the connection of a double-pole switch at
230Vac, allowing the resetting of a block type
fault
357
Fault indication (230Vac): the example shows
the connection of a 230Vac lamp
fig. 54
2.4 Gas connection
B
Before making the connection, check that the unit is arranged for operation with
the type of fuel available and carefully clean all the system gas pipes to remove
any residues that could affect proper functioning of the boiler.
Make sure all the gas connections are tight. The gas meter capacity must be suitable for the simultaneous use of all the
units connected to it. The diameter of the gas pipe leaving the boiler is not decisive for choosing the diameter of the pipe
between the unit and the meter; it must be chosen according to its length and pressure losses, in conformity with the
current regulations.
B
Do not use the gas pipes to ground electrical appliances.
19 20 21 22 23 24 25 26 27 28 29 30
1
2
3
4
5
6
7
8
9 10 11 12 13 14 15 16 17 18
357
301
302
N
L
L
N
Содержание TITAN 150
Страница 50: ...TITAN 50 IT cod 3541Z410 Rev 01 09 2022 fig 90...
Страница 142: ......
Страница 143: ......
