37
Variable brining function
Information
If the variable brining function is enabled, the brine tank will be filled for brine
preparation before regeneration.
Information
After every 10 regeneration cycles, the controller will perform the next regeneration
with no optimisation of the salt usage. This to preserve resin bed efficiency.
A
Use
and
to enable or disable the brining function.
B
Press
to confirm and switch to the next parameter.
Refill option
Information
This option is displayed only if
Vb
(brining function) is set to OFF.
Information
This option determines if the brine tank refill regeneration cycle is performed first
(0) or after (1) each regeneration.
A
Use
and
to set the brine tank refill.
B
Press
to confirm and switch to the next parameter.
Inlet water hardness
Information
This option is displayed only if
SH
(regeneration mode) is set to 1 or to 2.
Set the inlet water hardness in °f (French degrees), °d (German degrees)
or mg/L of CaCO
3
.
A
Use
and
to set the hardness.
B
Press
to confirm and go to the next parameter.
