La Cimbali M39 GT HD Dosatron, Использование и установка

Страница: 44 / 148

15. Clock adjustment
Use the “+” ( 30 ) and “-” ( 31 ) keys to adjust the clock.
The time increases (or decreases) one minute each time the
key is pressed.
If one of the keys (
30
or
31
) is pressed and held down for more
than 10 seconds, the minutes setting stops and the hours
setting increases (or decreases).
During the time setting phase, the seconds remain at "00".
16. How to access the programming mode
Note : When modifying data, the cursor changes to "

", or a
slide bar with maximum and minimum settings will appear:
If the " Customer Progr. " is set to "NO", the following message
will appear on the display:
Note. ONLY if the item “ Customer Progr. ” is set on “ YES "
and the item “
Program. block
” is set on “
NO
".
To access programming press the PRG ( 29 ) key; the following
message will appear on the display:
Press one of the dispensing keys on the selection panel ( 2 );
the relative led will remain on.
Use the “+” ( 30 ) and “-“ ( 31 ) keys to position the cursor (black
line) on the desired line, then press the PRG ( 29 ) key.
Always use the "+" ( 30 ) and "-" ( 31 ) keys to change the setting;
at this point there are two possibilities:
1) confirm the changes made by pressing the OK key
2) exit the menu and leave the settings unchanged by pressing
the RES key
-

+


CUSTOMER PROG.
KEY MENU
CUSTOMER PROG.
NOT ENABLED!
17. Key menu - Hot water selection
Press the hot water dispensing key ( 12 ). The following mes-
sage will appear on the display:
The following hot water selection parameters can be modi-
fied:
- water dispensing time (dispensing time in seconds.).
-

+


KEY MENU
Type dosed
dispens. time 05.0
12 12
22 April 2009
wednesday 15:15:04
88.6°C 89.4°C 91.4°C
English
English
42 EN