L3Harris Narda SignalShark, Руководство пользователя

Страница: 128 / 231

SignalShark User Manual
128
Setting the scan count number (Scan Count)
Sets the number of counted scans.
Changing the parameters:
1.
Tap the button and set the number of scans either by using the rotary control knob or by
entering the value.
2. Tap the OK button.
3.
Press the
Esc
key or tap the header to close the menu.
Defining the stop behavior (Stop Mode)
The stop mode value changes the behavior of the measurement engine, after the
Run
key is
pressed.
•
Hold
: Measurement continues in the background.
•
Stop
: Measurement stops and runs again.
You can stop/hold the measurement using the Run key.
To change these parameters:
1. Tap the toggle button to select Hold or Stop .
2. Press the Esc key or tap the header to close the menu.
Setting the detectors (Detectors)
Here you can do the following:
•
Enable/disable the detectors +Pk , RMS , Third Detector (detector depends on
Third Detector selection)
•
Select a third detector: -Pk ; Avg , Smp
•
Select which of these detectors is displayed in the waterfall diagram
To open the Detectors menu:
You selected the desired view.
1. Tap the Detectors button.
The
Detectors
menu opens.
2. Then you can do the following:
+Pk, RMS, Third Detector
Here you can switch the three detectors on / off.
To switch a detector on / off:
1.
Tap the detector to switch it
On
/
Off
.
2. Press the Esc key to close the menu.
Third Detector
For Third Detector following detector types can be selected:
• -Pk
• Avg
• Smp