Kyocera TASKalfa 3051ci, Руководство по обслуживанию

Страница: 284 / 317

2L6/2N6/2N5/2N4
1-4-283
(10) The leading edge of the image is consistently misaligned with the original.
(11) The leading edge of the image is sporadically misaligned with the original.
Print example Cause of trouble
1. Improperly adjusted leading edge timing.
2. Improper amount of slack of the original document in front of the registration.
Defective part Check description Corrective Action
1
Regist roller 1. Check whether the leading-
edge timing is adequately
adjusted.
If theadjustment is not sufficient, perform U034
to adjust the leading edge timing. (see page 1-
3-38)
2. Check whether the amount
of slack of the original
document when it reaches at
the DP regist is adequate.
If the amount of the slack in front of the regist
roller is insufficient, perform maintenance
mode U051 to optimize the slack. (see page 1-
3-45)
Print example
Defective part Check description Corrective Action
1
Paper feed clutch,
Middle clutch, Reg-
istration clutch,
Duplex clutch Check that the clutches are
properly fit.IOr, check they are
operative without a hinderance.
(30 ppm/35 ppm model) 1. If it is not fixed properly, fix it properly.
2. If it does not operate without a hinderance,
replace the clutch.
2
Paper feed clutch,
Middle motor, Reg-
istration motor,
Duplex motor Check that the clutches and
motors are properly fit.Or, check
they are operative without a
hinderance. (45 ppm/55 ppm
model) 1. If it is not fixed properly, fix it properly.
2. If it does not operate without a hinderance,
replace the clutch or motor.