Kyocera ECOSYS FS-C8500DN, Руководство по эксплуатации

Страница: 48 / 240

3-8 Handling Paper
printing. No liability will be assumed if moisture and so forth given off
during printing on special paper causes harm to the machine or operator.
Transparency
Transparencies must be able to withstand the heat of fusing during the
printing process. The recommended transparency product is 3M CG3700
(Letter, A4).
The table below lists the specifications for transparency:
To prevent printing problems, feed transparencies into the printer one
sheet at a time from the
MP tray . Always load the transparencies vertically
(with the long edge towards the printer).
If the transparencies have rough edges on the back, it may cause a paper
jam. Remove the rough edges, reverse the sides or feed the sheet from
the opposite edge.
When unloading transparencies (e.g., for clearing jams), hold them
carefully by the edges to avoid leaving fingerprints on them.
Note
Before purchasing any type of special paper, test a sample
on the machine and check that printing quality is satisfactory.
Item Specification
Tolerance of heat Must tolerate at least 190 °C (374 °F)
Thickness 0.100 to 0.110 mm (3.9 to 4.3 mils)
Material Polyester
Dimensional accuracy ±0.7 mm (±0.0276 inches)
Squareness of corners 90° ±0.2°