Kubota Z751KWi, Руководство оператора

Страница: 89 / 102

5. Measure from the right front blade tip to the level
surface with a short ruler or leveling gauge.
6. Turn the blade 180° and measure from the right
rear blade tip to the level surface.
7. Check that the left side blade has the same
dimensions. The difference between both
measurements should be less than 6 mm (0.25 in.).
The front side must be lower than the rear side.
8. If the front-to-rear adjustment is not within the given
tolerance, adjustment is necessary.
(1) Blade (A) Front
(B) Rear
(H) Height of blade
Front-to-rear adjustment
Less than 6 mm (0.25 in.)
The front side must be lower than the
rear side.
Adjusting the level (front-to-rear)
1. Raise up the mower deck to the top position.
2. Turn the cutting height set dial to the 76 mm (3 in.)
cutting height position.
3. Place 51 mm (2 in.) height wood blocks under each
side of the mower deck.
Anti-scalp rollers must not rest on the wood block.
4. Lower the mower deck.
5. Loosen the jam nuts of the front side of the
machine.
6. Adjust the cutting height fine tuning bolts to set
76 mm (3 in.) blade height.
Both front side bolts must be adjusted.
7. Tighten the jam nuts.
8. Adjust the other side equally.
IMPORTANT :
• The difference between both measurements
should be less than 6 mm (0.25 in.).
The front side must be lower than the rear
side.
9. Check the front-to-rear level. If it is not level,
adjustment is necessary.
(1) Cutting height fine tuning bolt
(2) Jam nut
ADJUSTMENT MOWER DECK LEVEL
84
Z751KWi,Z781KWi,Z781KWTi