Kubota LA535, Руководство по сборке

Страница: 41 / 51

37 ASSEMBLY INSTRUCTIONS
A Make sure the hooks at both sides are properly
mounted on the main frame.
11.Slowly operate the loader-control-lever to the up
position until the cutting edge of the bucket comes up
slightly off the ground. Then make sure the right and
left mounting levers are in the locked position.
Dismount and remount the loader if the cutting edge of
the bucket is off the ground but the mount hooks are
not locked.
12.Make sure the stand lever is at its low position as
shown in the following figure.
13. Raise the boom until the bucket pivot pin is the height
of the boom pivot pin.Then dump bucket slowly until
the stands are in the stowed position.
14. Using the stand lever, lock the stands in the stowed
position as shown below.
A
Do not force the stand lever if it gets twisted halfway
and fails to stow away the stand. In such case, lower
the stand lever and move the bucket to the full roll back
position. Then go back to step 11 and take the
following steps.
(1) Mount hook
(2) Mounting lever
(1) Stand lever
(1) Bucket pivot pin
(2) Boom pivot pin (A) Same height
(1) Stand lever