KTM F8103S4, Инструкции по установке

Страница: 5 / 36

SETUP 2
3
2.1 Transport mode
H02712-01
This vehicle was blocked for transport in the software.
To operate the vehicle, the vehicle electronics must be enabled.
This process is conducted during initial setup in KTM Dealer.net.
Enabling ensures that the initial setup in KTM Dealer.net is docu-
mented.
Enabling can be performed either temporarily, e.g. for a test ride,
or permanently for vehicle handover.
Info
Make sure that the vehicle is permanently enabled before
handing it over to the customer.
2.2 Unpacking and setting up the vehicle
Condition
Packaging V2
–
Unpack and set up the V2 vehicle. ( p. 5)
–
Remove V2 headlight mask. ( p. 5)
Condition
Packaging V12
–
Unpack and set up the V12 vehicle. ( p. 6)
–
Install V12 fork legs. ( p. 6)
–
Install V12 shock absorber. ( p. 7)
–
Install C12 combination instrument. ( p. 7)
–
Stick on the reflector. ( p. 8)
–
Install handlebars. ( p. 8)
–
Install the handlebar cushion. ( p. 9)
–
Install left side controls. ( p. 9)
–
Install right side controls. ( p. 11)
–
Install left and right rear mirrors. ( p. 12)
–
Install left and right hand guards. ( p. 12)
–
Install front fender. ( p. 13)
–
Install the front wheel. ( p. 13)
–
Install the front and rear turn signals. ( p. 14)
–
Install the license plate lamp. ( p. 15)
–
Install the reflector. ( p. 15)
–
Route the front turn signal cable. ( p. 15)
–
Route the rear turn signal cable. ( p. 16)
–
Install the license plate holder extension. ( p. 19)
–
Remove the motorcycle from the lift stand. ( p. 20)
–
Install the engine guard. ( p. 20)
–
Install the footrests. ( p. 20)
–
Charge the 12 V battery. ( p. 22)
–
Install the headlight mask with the headlight. ( p. 24)
–
Check the headlight setting. ( p. 24)
–
Set the combination instrument. ( p. 25)
–
Set kilometers or miles. ( p. 26)
–
Set the clock. ( p. 26)
–
Refuel. ( p. 27)