KTM F8103S4, Инструкции по установке

Страница: 16 / 36

3 SERVICE WORK ON THE CHASSIS
14
H00935-10
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change front wheel bearing.
–
Clean and grease shaft seal rings
1
and contact surfaces
A
of the spacers.
Long-life grease ( p. 33)
–
Insert the spacers.
–
Clean and grease the wheel spindle.
Long-life grease ( p. 33)
E00972-10
–
Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
2
.
Guideline
Screw, front wheel
spindle M20x1.5 35 Nm (25.8 lbf ft)
–
Operate the hand brake lever several times until the brake lin-
ings are seated correctly against the brake disc.
–
Remove the motorcycle from the lift stand. ( p. 20)
–
Operate the front brake and compress the fork a few times
firmly.
The fork legs straighten.
–
Tighten screws
3
.
Guideline
Screw, fork stub M8 15 Nm (11.1 lbf ft)
3.16 Installing front and rear turn signals
E00966-10
–
Position the turn signal on the headlight mask on both sides,
mount nuts with washers and tighten.
–
Mount turn signal relay
1
with lock washer
2
and
screw
3
.