KSB Delta Primo F, Инструкция по установке и эксплуатации

Страница: 69 / 80

10 Related Documents
69 of 80
KSB Delta Primo
1983.811/02-EN
Parameter Description Factory setting Possible
settings Min.
value Max.
value Read access
right Write access
right
4-3-3
HMI FW-Revision
IO information on revision of
HMI
- - - - Everybody Nobody
4-3-4 HMI HW-Revision
IO information on hardware
of HMI
- - - - Everybody Nobody
4-4 Profibus Info
Information on Profibus used
- - - - Everybody Everybody
4-4-1
PB FW-Version
Information on firmware of
Profibus
- - - - Everybody Nobody
4-4-2 PB FW-Revision
Information on firmware of
Profibus
- - - - Everybody Nobody
4-4-3 PB HW-Revision
Information on hardware of
Profibus
- - - - Everybody Nobody
4-5 Modbus Info
Information on Modbus used
- - - - Everybody Everybody
4-5-1
MB FW-Version
Information on firmware of
Modbus
- - - - Everybody Nobody
4-5-2 MB FW-Revision
Information on revision of
Modbus
- - - - Everybody Nobody
4-5-3 MB HW-Revision
Information on hardware of
Modbus
- - - - Everybody Nobody
5 Quickmenu
Information on quick menu
- - - - Everybody Nobody
10.3 Fault messages
Table 25: Overview of fault messages
Fault message Description Type of message
Warning Alert
Failure PT. Dis. Fault, discharge-side pressure sensor - ✘
Sys. press.to low System pressure below minimum pressure - ✘
Sys press.to high System pressure above maximum pressure - ✘
No water Insufficient fluid or insufficient inlet pressure on suction
side - ✘
Maintenance req. Service interval exceeded ✘ -
More pumps fail Multiple pump faults - ✘
No refresh tank 1 Insufficient water replacement, tank 1 - ✘
No refresh tank 2 Insufficient water replacement, tank 2 -
✘
No refresh tank 3 Insufficient water replacement, tank 3 -
✘
Aver temp to high Average temperature of water flow detection too high -
✘
Curr temp to high Current temperature of water flow detection too high ✘ -
Temp. Fail. Pump 1 Fault (temperature, motor protection switch, etc.),
pump 1 ✘ -
Temp. Fail. Pump 2 Fault (temperature, motor protection switch, etc.),
pump 2
✘
-
Temp. Fail. Pump 3 Fault (temperature, motor protection switch, etc.),
pump 3 ✘ -
Temp. Fail. Pump 4 Fault (temperature, motor protection switch, etc.),
pump 4 ✘ -