kruss DSA100, Инструкция по установке и эксплуатации

Страница: 74 / 115

page 72 Environmental chambers TC30 and TC40
11.5.3 External temperature sensor
The temperature above the sample can be measured with the help of an external
temperature sensor.

If the heat conducting hood is used then this must be placed in position before
the temperature sensor is inserted.
 With the sample drawer closed, slide the sensor into the guide on the top of the
chamber.
!
Make sure that the inserted samples do not come into contact with the
sensor; if necessary pull the sensor out slightly.
 Connect the temperature sensor to the connector on the DSA100 provided for
the purpose (

Chapter 5.8).
11.5.4 Inert gas connector
SPAC SPAC SPAC SPAC
Use only inert gases such as nitrogen or argon. Do not use gases which are
harmful, poisonous, inflammable or corrosive.
SPAC SPAC SPAC SPAC
1. Remove the screw on the rear of the chamber.
2. Screw the connection socket supplied with the chamber into the thread.