Krone Vario Pack 1510, Руководство по эксплуатации, Страница: 62 / 100

VIII - 4
Maintenance
8.4 Maintenance Tasks
8.4.1 Special Safety Instructions
To ensure trouble-free operation of the round baler and to minimize wear, maintenance should
be carried out at specific intervals. This includes the cleaning, greasing, lubrication and oiling
of assemblies and components.
8.4.2 General Information
Check nuts and bolts regularly (approximately every 50 hours) for tightness and tighten if
necessary!
• Maintenance, cleaning and repair work should be done only when the machine is at a
complete standstill. Switch off the motor, remove the ignition key and disconnect the
12 V supply voltage.
• Secure the tractor and round baler against rolling.
• If the tailgate is open, secure it at the shut-off tap to prevent it from falling.
• After completing maintenance work reattach all protective plates and protective devices
properly.
• Avoid skin contact with oil and grease.
• In case of injuries caused by oils, seek immediate medical assistance.
• Follow all further safety instructions to avoid accidents and injuries.
A = thread size
(resistance class is visible on the head of the bolt)
Torque moment M
A
(unless otherwise specified)
8 . 8
1
0 . 9
A
KR-1-130
A
Ø
5.6 6.8 8.8 10.9 12.9
M
A
(Nm)
M 4 2,2 3,0 4,4 5,1
M 5 4,5 5,9 8,7 10
M 6 7,6 10 15 18
M 8 18 25 36 43
M 10 29 37 49 72 84
M12 42 64 85 125 145
M14 100 135 200 235
M14x1,5 145 215 255
M 16 160 210 310 365
M16x1,5 225 330 390
M 20 425 610 710
M 24 730 1050 1220
M 24x1,5 350
M 24x2 800 1150 1350
M 27 1100 1550 1800
M 27x2 1150 1650 1950
M30 1450 2100 2450
Max. tightening torque of the sensors: 10 Nm