Krone Big Pack 1290 HDP, Оригинальная инструкция по эксплуатации, Страница: 208 / 422

16 Settings
16.9 Checking/setting the twine pusher
208
BiG Pack 1290 HDP XC
Original Operating Instructions 150000752_01_en
ü
The twine pusher shaft is tensioned, refer to page 211 .
„ Simulating a big bale, refer to page 207 .
„
In order to tighten the tensioning arm (1), pull back the upper twine (3) in front of the twine
guide eye (2).
„
Trigger the tying process manually with machine at standstill, refer to page 116 .
„
Turn the flywheel manually in working direction until the upper needle (4) raises, refer to
page 117 .
„
Turn the flywheel manually in the working direction until the knotter needle (5) nearly
touches the upper twine (3).
ð
At this point in time, the upper twine (3) must be centred in front of the knotter needle
(5).
If the upper twine is not centred in front of the knotter needle:
„
Align the upper needle by using a mounting lever until the upper twine is centred in front of
the knotter needle.
If the upper twine is centred in front of the knotter needle:
„
Keep turning the flywheel manually in working direction until the knotter gearbox is in idle
position,
refer to page 117 .
Æ
The knotting process is finished. The upper twine moves slightly to the right while the
flywheel continues to rotate. This is structurally determined as the knotter needle guides the
upper twine into the blade lever.
16.9 Checking/setting the twine pusher
BPG000-054
The twine pusher (3) pushes the twine away from the needle and pushes it against the knotter
hook. If the twine pusher (3) does not grab the twine, the knotter hook cannot pick up the twine.
Then, the twine pusher must be set.
Checking/setting the twine pusher relative to knotter needle (needle yoke)
ü
The twine pusher shaft is relieved, refer to page 211 .