Krone Big Pack 1290 HDP, Оригинальная инструкция по эксплуатации, Страница: 207 / 422

Settings 16
Simulating a big bale 16.7
BiG Pack 1290 HDP XC
Original Operating Instructions 150000752_01_en 207
NOTICE! Damage to the knotter needles! If the direction setting of the plunger is not taken
into account, the knotter needles may be damaged. The dimension X must only be set in the
working direction of the plunger (1) (refer to the arrow in the figure).
„
To do this, turn the flywheel manually in the working direction until the dimension is X=60–
90 mm , refer to page 117 .
„
Install the universally-jointed drive shaft of the knotter shaft and secure it.
„
Initiate the tying process again manually, refer to page 116 .
„ Recheck the position of the knotter needles to the plunger.
„
Set the spring tension of the needle brake, refer to page 205 .
16.7 Simulating a big bale
BP000-171
ü
The machine is shut down and safeguarded, refer to page 26 .
ü The upper twine is threaded, refer to page 104 .
ü
The lower twine is threaded, refer to page 103 .
ü
The upper and lower twine are knotted.
„ Make a catch hook (1).
„
In order to simulate a tied big bale, pull the twine (2) with the catch hook out of the bale
channel and fix it on the top of the baling flap with a shaft (3).
Alternatively, a screwdriver instead of a shaft (3) can be used.
16.8 Checking/setting the upper needle
BP000-181
ü
The upper needle is tensioned.