Krone Big Pack 1290 HDP, Оригинальная инструкция по эксплуатации, Страница: 69 / 422

Initial operation 7
Adjusting universal shaft [BYPY] 7.4
BiG Pack 1290 HDP XC
Original Operating Instructions 150000752_01_en 69
Removing/adapting lubrication line
BP000-089
„
Unscrew the grease nipple (2) from the inner section tube (1) and pull the lubrication line (3)
out of the inner section tube (1).
„
Shorten the lubrication line (3) by X=5cm.
From the separated section tube (4)
„
Tap out the roll pins (5) to the inside.
„
Pull the lubrication line (6) out of the separated section tube (4) and remove the end piece
(7).
„
Attach the end piece (7) onto the shortened lubrication line (3).
„ Drill a borehole Ø 4 mm at a distance of X2=5 cm into the inner section tube (1) at the top
and the bottom.
Make sure that the boreholes are on the same side as the borehole of the grease nipple
„
Insert the lubrication line (3), screw in the grease nipple (2) and drive in the roll pins (5).
Mounting universal shaft halves
BP000-087
Inner universal shaft half
„
Grease the raceway seat of the inner section tube (1).
„ Insert the inner raceway (2) into the groove.
„
Slide on the inner guard tube (4) and secure with screws (3).