Krone Big Pack 1290 HDP, Оригинальная инструкция по эксплуатации, Страница: 303 / 422

Malfunction, cause and remedy 23
Malfunctions electrics/electronics 23.1
BiG Pack 1290 HDP XC
Original Operating Instructions 150000752_01_en 303
Possible cause Remedy
FMI 13: The values of the calibration are outside the value range.
The sensor is defective. „
Have the sensor replaced.
522087-
Measuring/Calibrating
Possible cause Remedy
FMI 17: The lower limit value has been reached.
The sensors "Measure" and
"Calibrate" have been mixed
up. „
Swap the plugs of the sensors "Measure" and "Calibrate”.
522088-
Packer feed
Possible cause Remedy
FMI 7: The mechanics do not respond or the expected result was not achieved.
The sensor B7 “Packer feed
active“ has not been set prop-
erly. „ Have the sensor adjusted.
522091-
Malfunction in the packer feed.
Possible cause Remedy
FMI 7: The mechanics do not respond or the expected result was not achieved.
The sensing rake jams. „
Eliminate the cause of jamming.
The star wheel is defective. „ Have the star wheel exchanged.
The tripping ratchet of the
Variable Filling System (VFS)
is broken:
„
Have the tripping ratchet exchanged.
522101-
B 8
Sensor B8 “Lower twine“
Possible cause Remedy
FMI 4: There is a cable break, cable break/short circuit, general error or undervoltage.
FMI 5: There is a cable break, general error or overload.
The sensor is damaged ex-
ternally. „ Check sensor and wiring for damage, refer to page 281 .
The sensor wiring is faulty.
522102-
B 6
Sensor B6 “Rotational speed of packer“
Possible cause Remedy
FMI 4: There is a cable break, cable break/short circuit, general error or undervoltage.
FMI 5: There is a cable break, general error or overload.
The sensor is damaged ex-
ternally. „
Check sensor and wiring for damage, refer to page 281 .