Krone Big Pack 1290 HDP, Оригинальная инструкция по эксплуатации, Страница: 209 / 422

Settings 16
Checking/setting the twine pusher relative to the channel slot 16.10
BiG Pack 1290 HDP XC
Original Operating Instructions 150000752_01_en 209
Checking the twine bars
„
Trigger the tying process manually with machine at standstill, refer to page 116 .
„ Turn the flywheel manually in working direction until the lower needle (1) (needle yoke) is
just in front of the twine driver (2),
refer to page 117 .
„
Apply flywheel brake refer to page 98 .
„ Pull the linch pin and swivel up the knotter.
„
By turning the twine pusher, swivel the twine bar (3) to the middle of the knotter needle (1)
and check dimension X.
Æ If the dimension is X=2-4 mm , the setting is correct.
Æ
If the dimension is not X=2-4 mm , the twine pusher must be set.
„ Repeat this process for all twine pushers (1).
Setting the twine bars
„ Loosen the nut (4).
„
Move the twine pusher (3) until the dimension is X=2–4 mm .
„
Tighten the nuts (4).
„
Swing the knotter down and secure with the linch pin.
„
Repeat this process for all twine pushers (1).
„ Release flywheel brake, refer to page 98 .
„
Finish the tying process manually, refer to page 117 .
„ Apply flywheel brake refer to page 98 .
„
Tension the twine pusher shaft, refer to page 211 .
„
Check/set twine pusher relative to the channel slot, refer to page 209 .
„
Check the overreach of the twine pusher at second knot, refer to page 210 .
16.10 Checking/setting the twine pusher relative to the channel slot
BPG000-050
„
Disconnect machine from tractor, refer to page 195 .
„
Apply flywheel brake refer to page 98 .
„ Check if the knotter gearbox is in idle position, refer to page 117 .