Kromschroder E8.5064 V1, Руководство по эксплуатации

Страница: 21 / 64

Part 2: Overview of display values and settings
Display Range
21
Hot water
T-DHW DES Current hot water set temperature
according to heating program and
operating mode
T-DHW Current hot water temperature
T-DHW L Temperature of HW tank in the lower
section (infeed)
T-CIRCL Return flow temperature of the circulation
RETURN
Exit level using
Ä
Heating circuit I / II
T-ROOM DES A Current room set temperature
according to heating program and
operating mode
T-ROOM Current room temperature
HUMIDITY *** )
Display of room humidity (if value is
available)
T-POOL DES
*
)
Swimming pool temperature setting
T-POOL *) Current swimming pool temperature
T-DHW DES
**
)
Hot water temperature setting
T-DHW
**
)
Current hot water temperature
T-FLOW DES Current flow temperature setting
T-FLOW Current flow temperature
N-OPTI-TIME Previous time required to heat up
with heat-up optimisation activated
RETURN
Exit level using
Ä
!
Display only appears if the sensor is connected and
the value is present in the system.
If the set value is not present it is masked out, or
hyphens appear in the display (- - - -).
T-DHW L (storage tank lower temperature)
For example for solar infeed or for active charge-through
function (CHARGE-THROUGH = 01). Display hot-water
tank temperature in infeed area.
T-ROOM DES A (current value for set room
temperature)
If a control unit is connected there will be no display
"- - - -" => display on control unit
T-ROOM (room temperature)
Only if a sensor or a FBR is connected.
*
) These values only appear if the heating circuit is
programmed as a controller for the pool.
**
)These values only appear if the heating circuit is
programmed as a hot water circuit.
***) These values only appear if an operating device is
connected and parameters have been set for the
corresponding heating circuit.
“- - - -„ => no humidity sensor available in control device