Kratki LEO/100, Инструкция по эксплуатации

Страница: 59 / 63

Minimum inlet pressure (in. w.c./kPa)::
Voltage rating (V):
Frequency (Hz)
5,0/1,25
6
50
This appliance is only for use with the type of gas indicated on the rating plate and may be installed in an
aftermarket, permanently located, manufactured home (USA only) or mobile home, where not prohibited
by local codes. See owner's manual for details. This appliance is not convertible for use with other gases.
This appliance is approved to be installed with type B venting system. For specified, listed system
approved to be used with this appliance, please refer to the owner’s information manual.
LIGHTING, OPERATING AND SHUTING OFF INSTRUCTIONS.
This appliance is approved to be operated with remote controler provided only. Do not try to
start it any other way.
TURNING ON
• Press the button on your remote controler until you hear two short beeps. Starting the firing
sequence is confirmed by the occurrence of a flashing icon on the display of the burner. Release
the button.
• Kindling the control flame is confirmed by a single signal.
• After kindling the main burner, the remote control automatically switches to the manual mode.
• To make the unit switch to the standby mode, hold the button until the main burner is
extinguished.
SHUTING OFF
• To turn the device off, press . The control flame will be extinguished.
• Before attempting to re -start the fireplace, wait 5 seconds.
SAFETY SHEET
This appliance must be installed in accordance with local codes, if any; if none, follow the
National Fuel Gas Code, ANSI Z223.1/NFPA 54, or Natural Gas and Propane Installation Codes,
CSA B149.1
WARNING: Improper installation, adjustment, alternation, service or maintenance can cause
injury or property damage. Refer to the owner’s information manual provided with this
appliance. For assistance or additional information consult a qualified installer, service agency or
the gas supplier.
• This appliance must be properly connected to a venting system in accordance with the
manufacturer’s installation instructions.
• This appliance may be installed in an OEM installation in a manufactured home (USA only) or
mobile home and must be installed in accordance with the manufacturer’s instructions and the
Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 , in the United States,
or the Standard for Installation in Mobile Homes, CAN/CSA Z240 MH Series , in Canada.
• This appliance may be installed in a recreational vehicle also and must be installed in accordance
with the Standard CAN/CSA Z240 RV, Recreational Vehicles , in Canada, or with ANSI A119.2/NFPA
501C, Standard for Recreation Vehicles, in the United States.
In case of any removal, swaping or maintaining of the venitng system it is necessary to reinstall
or/and reseal the vent-air intake system properly. Improper reinstallation or resealing can cause
serious injury or property damage.
This appliance is approved to be installed with type B venting system. For specified, listed system
approved to be used with this appliance, please refer to the owner’s information manual.
CAUTION: Hot while in operation. Do not touch. Severe Burns may result. Keep children, clothing
and furniture, gasoline and other liquids having fl ammable vapors away. Keep burner and control
compartment clean. See installation and operating instructions accompanying appliance.