![Kratki LEO/100 Скачать руководство пользователя страница 56](http://html1.mh-extra.com/html/kratki/leo-100/leo-100_manual-instruction_2002586056.webp)
8
Decorative
elements
Make sure that decorative elements do not require cleaning.
Make sure decorative elements are not in contact with the glass.
Make sure that decorative elements are not damaged.
WARNING!!!
Locking the pressure regulator is realized by the maximum tightening its adjusting screw.
Environmental protection
•
All elements of the packaging in which the gas insert was supplied should be disposed of in an
appropriate manner for their type.
• Due to the heavy metal included, the batteries are classified as hazardous chemical waste, so, after
use, they should be thrown into special containers for hazardous waste.
• If the device operation is over, yo
u should dispose of it. The user is obliged to submit the fireplace to
an appropriate institution handling recycling this type of equipment.
POSSIBLE PROBLEMS AND SOLUTIONS
NOTE!!!
Removal of defects or replacement of system components for gas control can only be done by an
authorized service technician.
There are many factors that could affect the gas insert malfunction. To exclude a possible fault in the
unit or the automatic gas control system, be sure that the fireplace is connected in accordance with
these instructions. The table below shows how to proceed in the case of individual symptoms.
NOTE!!!
Making replacement of damaged parts, use only original components offered by the manufacturer.
FAULT
SUGGESTED ACTIONS
The device will not start
(no audible confirmation
of the ignition procedure)
✓
Replace the batteries in the remote control and the
receiver.
✓
If the receiver is powered by the power module assess its
performance.
✓
Reset the receiver and program a new transmission code.
✓
Make sure the receiver antenna is properly installed and
not damaged
No voltage on the
controller coil (there are
no specific „clicks”)
✓
Make sure the switch cord in the gas control module is not
damaged.
✓
Short cyclical signals appearing when you try to switch on
the fireplace indicate the need to replace the batteries in
the receiver.
✓
For one long beep:
Содержание LEO/100
