KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the VP-725DSA Presentation Switcher / Scaler
12
6 Connecting the VP-725DSA Presentation Switcher / Scaler
This section describes how to connect the
VP-725DSA
. In particular, how to:
Connect the
VP-725DSA
rear panel (see this section)
Connect the
VP-725DSA
MASTER OUT connector (see section 6.1)
Connect the interlaced and progressive RGBS and RGsB inputs (see section
6.2)
Connect the PC (see section 6.3)
Connect the Ethernet port (see section 6.4)
Connect the audio inputs/outputs (see section 6.5)
Using the
VP-725DSA
you can select any one of the 18 inputs and scale that
input to up to three scaled outputs (at the identical resolution).
To connect the
VP-725DSA
, connect the following
1
to the rear panel, as the
example in Figure 3 illustrates:
1. Connect one or more of the following video sources:
Up to four VGA graphics sources (for example, computers): VGA
Source 1, VGA Source 2, VGA Source 3 and VGA Source 4 to the
HD15 input connectors
2
Up to four composite video sources
3
: CV Source 1, CV Source 2, CV
Source 3, and CV Source 4 to the BNC input connectors
Up to four s-Video sources
3
: YC Source 1, YC Source 2, YC Source
3, and YC Source 4 to the 4p input connectors
Up to four component video (sometimes called YUV, or Y, B-Y,
R-Y, or Y, Pb/Cb, Pr/Cr) sources or 4 RGB sources to the four sets of
3 BNC connectors, G/Y, B/Pb, and R/Pr. The example in Figure 3
illustrates an HDTV satellite receiver or an RGB camera connected
to COMP Source 4
Up to two DVI
4
graphics sources (for example, computers): DVI
Source 1 and DVI Source 2 to the DVI connectors
1 Switch OFF the power on each device before connecting it to your VP-725DSA. After connecting your VP-725DSA, switch
on its power and then switch on the power on each device
2 These connectors also accept interlaced and progressive RGBS and RGsB signals (see Table 3)
3 For example, VCR machines
4 Not HDCP sources