COMPLETE THE INSTALLATION
1. A) Secure the stud tabs located on the sides of the unit to the stud walls.
B) Use screws (not provided) to secure the unit to the flooring through the holes located in the bottom of the
outer box.
IMPORTANT
- MOBILE HOME INSTALLATIONS: THE FIREPLACE MUST BE SECURED TO THE
FLOOR.
C) Complete the fireplace walls, and the unit facing.
CAUTION:
THE SURROUNDING WOOD CHASE OF THE OUTSIDE WALL MUST BE INSULATED TO PREVENT COLD AIR FROM ENTERING THE ROOM.
2.
THIS STEP SHOULD ONLY BE DONE BY A QUALIFIED INSTALLER OR SERVICE TECHNICIAN:
A) Perform lighting and shutdown procedures as described on pages #20-21 . This should be done prior to
replacing the glass so that any necessary adjustments can be made and proper operation verified.
3. Replace the glass. Refer also to Figure 7, pg.11.
A) Align the slots in the top of the glass assembly over the tabs on the fireplace.
B) Place the glass assembly so it is flush with the front of the fireplace front.
C) Secure the assembly to the fireplace by pulling the two spring loaded handles (located under the firebox)
out and up over the latch brackets. Release, locking them into position.
4. Upper Grill - Install:
A) Line the rods of the grill up with the upper holes.
B) Place the rods in the holes and push up until the bottoms of the rods clear the glass frame.
C) Place the bottom of the rods into the lower holes and release. The grill will set down into place.
Remove:
A) Lift the upper grill up far enough to clear the bottom holes and pull bottom of grill out.
5. Lower grill - See Figure 12
Replace:
A) Remove the 1/4" nuts (B) from the lower
grill assembly.
B) Slip the bolt through the hinge (A).
C) Re-attach the 1/4" nut (B).
D) Repeat “A” through “C” for the remaining
hinge.
The grill is now in place. The grill may be lowered
for accessing the control valve, service, etc.
Remove:
A) Remove the 1/4" nuts (B) from the
lower grill assembly.
B) Pull the entire grill assembly out of
the hinges.
C) Re-attach the 1/4" nuts (B).
WARNING:
DO NOT OPERATE THIS FIREPLACE WITH THE GLASS ASSEMBLY REMOVED, CRACKED OR BROKEN.
Replacement of the glass assembly, part #700-07T should be done by a licensed or qualified service person.
FIGURE 12
Page 18
