THERMOSTAT - WALL SWITCH - REMOTE INSTALLATION (OPTIONAL)
NOTE:
INSTALLATION OF A THERMOSTAT OR WALL SWITCH SHOULD ONLY BE DONE BY A QUALIFIED
INSTALLER.
If desired, a thermostat (wireless style available), wall
switch, or remote control assembly may be used to
turn the fireplace ‘OFF’ and ‘ON’. ONLY one of these
may be installed. Follow instructions included with
each assembly.
NOTE: OPEN THE VALVE COVER TO EXPOSE THE
GAS VALVE AND WIRE CONNECTION ON THE
VALVE TERMINALS.
Disconnect the on/off rocker switch wires from the top
& bottom terminals on the gas valve.
Follow instructions included with the remote control.
Remote Control Wiring Diagram
CAUTION:
DO NOT CONNECT HIGH VOLTAGE (115V) WIRE TO THE GAS VALVE!
REMOTE CONTROL USERS:
IMPORTANT:
The insulated cover included with
the remote control must be placed over the remote
receiver to protect it from overheating.
CONTROL USERS
Run low-voltage (thermostat) wires from the terminals
on the gas valve to the desired location of the wall
switch or thermostat.
Attach the appropriate connector to each wall switch /
thermostat wire and connect to the top and bottom
terminals on the gas valve marked ‘TH’.
WALL SWITCH / THERMOSTAT USERS:
Thermostat Wiring Diagram
Page 17
