kozy heat 961 DV, Инструкция по установке и эксплуатации

Страница: 23 / 34

Page 19
J. COMPLETE THE INSTALLATION
1. SECURE THE FIREPLACE
Note: Nailing flanges are attached to the sides of the fireplace.
A. Loosen but do not remove the screws securing the nailing flanges to the fireplace. Remove nailing flanges.
B. Locating the keyhole slots on the nailing flange, simply place over the screws and slide forward to the desired
position, then tighten the screws.
C. The tabs can now be bent parallel with the fireplace.
D. Fasten to framing through the holes in the nailing flanges.
Figure15
2. ATTACH THE EXTERIOR TRIM PIECES (OPTIONAL).
Two sets of exterior trim are included with this fireplace
and are used if a finished edge is desired when using
tile, marble etc. around the fireplace face. This trim is
also used when the fireplace is installed in a Kozy Heat
cabinet or surround. Attach the appropriate set for your
application.
Align the (3) holes on each side of the fireplace to the
slots on each trim piece and secure with the screws
provided (3 ea. Side). Figure 15.
3. COMPLETE THE FIREPLACE WALLS AND FACING.
CAUTION: The surrounding outside walls must be insulated to prevent cold air from entering the
room.
MASONRY CONSTRUCTION: A lintel, Part #788B, must be used to support the added weight when
masonry construction is used. Follow the instructions below.
Referring to Figure 16:
Optional: MASONRY CONSTRUCTION ONLY!
The stand-off brackets located on top of the
fireplace may be removed.
A. Thread the ¼” coupling nuts (B) onto the lintel
rods (factory-installed) in the front corners of
the fireplace top.
B. Place the lintel iron (A) on the fireplace top with
the flange in the ‘up’ position as shown.
NOTE: Lintel should rest on the lintel rods in
the front corners and on the brick at both ends.
C. Complete brick installation, filling in all holes in
the brick with mortar.
Figure 16