kozy heat 961 DV, Инструкция по установке и эксплуатации

Страница: 19 / 34

Page 15
10. Remove the pilot shield and set aside. Figure 11B.
11. Loosen and remove the (8) 1/4" nuts securing the millivolt board and, while grasping the board, gently
lift it off the (8) studs and remove from the firebox. Figure 11C.
Figure 11C
INSTALLING THE BOARD.
NOTE: This fireplace is fitted with a gasket to seal the millivolt board. Make certain this gasket is properly placed
around the opening before installing the millivolt board.
1. Grasp the burner with both hands and place into the firebox, lining up the (8) 1/4" holes in the millivolt board to
the (8) studs on the firebox bottom. Refer to Figure 11C.
CAUTION: Before securing the board into place make sure that all of the wires (attached under the
board) are clear and unobstructed.
2. Attach the 1/4" nuts (included with the board assembly & tighten).
3. Re-install the pilot shield. Figure 11D.
4. Re-install the burner cover, aligning the mounting holes in the burner brackets
to the corresponding mounting studs on the bottom of the millivolt board.
Figure 11B.
IMPORTANT: Ensure that the burner tube is properly seated over
the burner orifice.
Figure 11D
5. Secure with the remaining (2) ¼” nuts. Figure 11B.
6. To position the adjustable venturi collar into its mounting bracket,
gently push the bracket back far enough to slip the flange on the
collar into the slot on the bracket. Figure 11E.
7. Connect the flexible gas line to the manual shut-off valve.
8. Re-connect any wall switch, thermostat or remote control wires to the valve.
9. Re-install the log grate, (Figure 11A, page #14), logs and
rock wool burning embers (page #17).
12. Light the pilot and burner to ensure proper ignition and operation.
13. Re-install the glass assembly and upper grill.
Figure 11E
IMPORTANT: CHECK ALL CONNECTIONS WHETHER FIELD OR FACTORY MADE FOR LEAKS.
1/4" NUTS SECURING BOARD
PILOT SHIELD