kozy heat 961 DV, Инструкция по установке и эксплуатации

Страница: 16 / 34

Page 12
INSTALLATION INSTRUCTIONS. REFER TO FIGURE 11B.
1. Remove the center front lower grill, if installed.
2. OPTIONAL: For easier installation, the fans may be separated by unplugging the three-prong plug from the
receptacle in the right fan assembly.
3. Lay the left fan (A) (without receptacle) on its back & slide through the lower grill opening on the
right
side of the
valve.
4. Rotate upright and slide to the left. Place the fan over the (2) left mounting studs (C) located towards the back of
the fireplace.
3. Lay the remaining fan (B) on its back and place over the right mounting studs (C) in the same manner as step #4.
4. Place nuts on mounting studs and tighten.
5. If the fans were separated in step #2 above, plug fans together by inserting the three-prong male end on the short
fan cord on the left fan assembly into the receptacle in the right fan assembly.
6. Remove the removable access panel (with electrical box & romex connector installed) from the side of the fireplace.
7. Insert 115V wiring (with ground) through the romex connector and wire to the speed control / receptacle assembly
matching the black (hot), white (neutral) and green (ground) wires to the corresponding wire on the speed control /
receptacle assembly. NOTE: (3) wire nuts are included in the fireplace components packet.
8. Secure the speed control / receptacle assembly (D) into the electrical box with the (2) screws provided.
9. Re-install the electrical access panel and secure.
10. Place the thermostatic control switch (with magnet) on the bottom of the firebox.
11. Plug the fan cord (E) into the receptacle in the electrical box.
12. Turn on/off speed control counter-clockwise until it ‘clicks’. This is the ‘OFF’ position.
13. Turn the speed control ‘ON’ by turning the knob clockwise past the ‘click’ - this is the highest setting.
14. Re-install the lower grill, if removed in step #1 above.
NOTE: The fan will not operate unless the speed control has been turned ‘ON’. The fan will not turn ‘ON’ until sufficient
heat is applied to the thermostatic control switch . The fan will turn ‘ON’ and ‘OFF’ automatically when the fireplace
heats and cools. Adjust fan to desired speed while it is running.
THERMOSTATIC CONTROL SWITCH POSITION: Prior to adjusting the thermostatic control switch, unplug the 3-prong
plug on the fan cord from the receptacle. Adjust the position of the thermostatic control switch to a warmer location
under the firebox to turn the fan ‘ON’ sooner or move it to a cooler location under the firebox to turn the fan ‘ON’ later.
The fan will turn on when the sensor in the temperature control switch reaches 110
o F and will turn ‘OFF’ when the
sensors reach 90
o
F. After adjustment, plug the 3-prong plug on the fan cord into the receptacle.
Figure 11B
Thermostatic
A
Control Switch
B
E
D C
White 3-prong
C
receptacle
NOTE: This appliance must be electrically grounded and connected in accordance with local codes, or in the absence of local codes,
with the National Electrical Code, ANSI/NFPA 70-Current edition.