kozy heat 961 DV, Инструкция по установке и эксплуатации

Страница: 22 / 34

Page 18
THERMOSTAT - WALL SWITCH - REMOTE CONTROL INSTALLATION
CAUTION: DO NOT CONNECT HIGH VOLTAGE (115 V) WIRE TO THE SWITCH
If desired, a thermostat, wall switch, or remote control
assembly may be used to turn the fireplace ‘OFF’ and
‘ON’. ONLY one of these may be installed. Follow
instructions included with each assembly.
OPTIONAL: Disconnect the on/off rocker switch wires
from the top & bottom terminals on the back side of
the gas valve. Refer to Figure 21, page #27.
NOTE: INSTALLATION OF A THERMOSTAT OR WALL
SWITCH SHOULD ONLY BE DONE BY A QUALIFIED
INSTALLER.
WALL SWITCH / THERMOSTAT USERS:
Run low-voltage (thermostat) wires from the terminals
on the gas valve to the desired location of the wall
switch or thermostat.
Attached the appropriate connector to each wall switch
/ thermostat wire and connect to the top and bottom
terminals on the gas valve.
REMOTE CONTROL USERS
:
Follow instructions included with the remote control.
IMPORTANT: The insulated cover included with the
remote control must be placed over the remote
receiver to protect it from overheating.
Remote Control Wiring Diagram
Figure 14B
Thermostat Wiring Diagram
Figure 14A
The ON/OFF rocker switch on the millivolt board
must be in the ‘OFF’ position for proper operation of
any of these components.
If the rocker switch is ‘ON’, the fireplace burner will
operate until it is turned ‘OFF’ by the rocker switch.
A wall switch, thermostat, or remote control will not
turn the fireplace ‘OFF’ when it has been turned ‘ON’
by the rocker switch.
NOTE: The fireplace must be turned ‘ON’ and ‘OFF’
by the same method. For example: If the fireplace is
turned ‘ON’ by the remote control, it must be turned
‘OFF’ by the remote control.