kozy heat 911-XXL, Инструкция по установке и эксплуатации

Страница: 26 / 39

LIGHTING AND SHUTDOWN (cont.)
PAGE 25
1. Set thermostat to the lowest setting, if installed.
2. Turn off all electrical power to the appliance. (Fan).
3. Open lower grill to access the gas valve & controls.
A. Push gas control knob in slightly and turn clockwise to OFF. Wait
five (5) minutes to allow any gas that may have accumulated inside
firebox to escape. If you then smell gas,
STOP! Follow safety
information on front cover and previous page of this installation
manual. If you don‟t smell gas, go to next step.
LIGHTING
E. Push gas control knob in slightly and turn counterclockwise to ON.
The burner can now be turned ON by depressing ON/OFF rocker
switch located beside valve or wall switch, OR by setting thermostat
or remote control to desired setting.
F. Turn on all electric power to appliance (if applicable).
NOTE: When fireplace is initially lit, condensation will appear
on the glass; this is normal in all gas fireplaces and will
disappear after several minutes.
B. Locate pilot - follow metal tube from gas control. (Located inside
combustion chamber).
C. Push gas valve control knob in slightly and turn counterclockwise to
PILOT. Push valve knob in and hold while repeatedly pressing piezo
igniter button until pilot is lit while continuing to hold in gas control
knob.
D. Hold gas control knob in for one (1) minute after pilot is lit. Release
gas control knob. If pilot goes out, repeat steps C-D. When pilot is
lit, proceed to step E.
NOTE: Gas control knob cannot be turned from PILOT to OFF
unless knob is pushed in slightly. Do not force .
CAUTION: If knob does not pop up when released, stop and
immediately call your service technician or the gas
supplier.
If pilot will not stay lit after several tries,
turn gas control knob to OFF and call your service
technician or gas supplier.
5 MINUTES
Figure 25a
E
D
C
B
A
PILOT
PILOT TUBE
1 MINUTE