kozy heat 911-XXL, Инструкция по установке и эксплуатации

Страница: 14 / 39

INSTALLATION
IMPORTANT: All steps as outlined in „PREPARE EXISTING FIREPLACE‟ must be completed before continuing with this installation.
Kozy Heat #815-CL Co-Linear Vent System. Follow instructions on following pages.
Selkirk
Follow instructions included from vent pipe manufacturer as well as venting requirements as outlined in this installation manual.
APPROVED VENTING
AIR DUCT REMOVAL
Remove air duct by lifting up and off top of insert. Follow instructions below and on
following pages for vent system attachment to air duct.
PAGE 13
Air Duct
Figure 13a
Large Restrictor Bend tabs to approx. 80 degree
angles to create tension to hold
itself in place when installed. Remove tab (s) to create
small restrictor Slide restrictor into exhaust pipe with tabs
pointing toward you.
RESTRICTOR INSTALLATION
Each installation is unique and affected by various factors including venting configuration, altitude and climate. Therefore, after fireplace
insert installation is complete, a restrictor may be required or may need to be removed or modified.
Page 29
has information on restrictor recommendations depending on burner flame appearance and instructions on installation after venting
is completed.
Figure 13b
IMPORTANT: Do not install if venting configuration is at minimum requirements.