kozy heat 911-XXL, Инструкция по установке и эксплуатации

Страница: 21 / 39

1. Remove nuts from upper grill. Place grill rods through holes in shroud top section. Secure with nuts.
2. Secure right and left shroud sections to top section by aligning holes in side sections to holes in top section. Secure from bottom with
screws provided (2 ea. side).
3. Snap rocker switch into place on shroud. Slide one connector on each rocker switch wire to the rocker switch.
OUTSIDE FIT APPLICATIONS:
1. Attach shroud to insert by inserting tabs (A) on left and right shroud sections to holes (B) in insert face. The shroud will set down into
place.
2. Slide remaining connectors on rocker switch wires to top and bottom terminals marked TH and THTP on gas valve.
3. Remove nuts from lower grill, insert grill bolts through lower hinges on insert. Attach and tighten nuts.
Snap On/Off rocker switch
into mounting hole as shown.
1. Remove glass frame assembly. Refer to page 9 if necessary.
2. Referring to illustration at right, use a tin snips to remove lower end of (4) mounting tabs on shroud
side sections.
MASONRY SHROUD ASSEMBLY & INSTALLATION
Shroud assembly includes: (1) Shroud top (8) Phillips head screws
(1) Shroud left side (1) Set „inside fit‟ brackets
(1) Shroud right side with on/off rocker switch mounting hole
You will need the following items from insert components packet: Rocker switch wires and On/Off Rocker
You will also need upper grill from grill set (sold separately) .
Screws are secured from bottom.
INSIDE FIT APPLICATIONS:
(You will require „inside fit‟ brackets included with shroud assembly).
PAGE 20
ATTACH SHROUD
Figure 20a
Figure 20b
Figure 20c