kozy heat 911-XXL, Инструкция по установке и эксплуатации

Страница: 16 / 39

We strongly suggest wrapping first 3ft. (914mm) of vent system below termination cap
with non-faced fiberglass insulation (secure with wire) before running it through existing
chimney. This will prevent cold air from coming down existing chimney.
NOTE: If offsets are present in existing chimney, it may be easier to place a weighted rope around the end of each pipe to guide them
through it. DO NOT ATTEMPT TO TIE ONE ROPE AROUND BOTH PIPES.
VENTING INSTALLATION
KOZY HEAT #815-CL CO-LINEAR VENT SYSTEM
(cont.)
1. Guide rope, if used, and flexible pipe(s) down existing chimney. See illustration at lower left.
2. To secure chimney termination cap to existing chimney, apply a liberal bead of sealant (provided) around top of existing chimney. Set
termination cap into position as instructed in installation manual included with chosen vent system.
3.
From inside existing fireplace opening, CAREFULLY pull ropes down until 4" exhaust pipe and 3” combustion air intake (if usin g
„full connection method‟), are into existing fireplace.
STUB VENTING : From inside existing fireplace, insert a minimum 4ft. (1.22m) section of combustion air pipe (end without collar) past
damper opening and into existing fireplace. See illustration at lower right.
We strongly suggested placing non-faced fiberglass insulation between vent pipes and existing chimney to prevent heat loss up chimney,
being careful not to block end pipe if using stub method.
PAGE 15
RUN VENTING THROUGH EXISTING CHIMNEY
Minimum 4ft. (1.22m) section
of 3" combustion air flex pipe
DO NOT block pipe
end with insulation or
any other sealing
materials
4" exhaust flex pipe
must be connected
to collar on
fireplace insert and
termination cap
Seal area around
vent pipes with
non-faced fiberglass
insulation
Figure 15a
Figure 15b