Konica Minolta ViZion DR+ 1417V2, Руководство по установке для дилеров, Страница: 23 / 32

[ViZion DR+ 1417V2 Wireless Panel Installation Manual]
[Ultra 4.2.9.0]
23
Customer Support 1.800.366.5343
–
HCITsupport@konicaminolta.com
Select 1 of the 2 following wireless methods:
4.7.2 Wi-Fi Configuration in Client Mode
(Recommended connection method)
1. Within the Detector tab, click on the
Wifi tab and select Client mode.
2. Click Add button and enter the following
info in the popup dialog box fields:
•
SSID = ViZionDREXAP
•
Key = 12345678
3. Then click Apply button.
4. Click Read Config button, and then
click Write Config button to save the
wifi setting into
panel’s ROM memory.
5. Wait for the
“State” at the bottom to
change back to Ready highlighted in
green and verify
“Message” at the
bottom of the screen shows success.
4.7.3 Wi-Fi Configuration in AP Mode
(Alternative connection method)
1. Within the Detector tab, click on the
Wifi tab and select AP mode.
2. Click Add button and configure the
fields with the following info:
•
SSID = enter the serial number for
the panel. (It is printed on the bar
code label on the back of the panel)
•
Key = 12345678
•
Security = Wifi_WPA_WPA2_PSK
•
Frequency = Wifi_Freq_5GHz
•
Country = Wifi_Country_US
•
Band = Wifi_Band_HT20
•
Channel = Wifi_Chnl_157
3. Click Read Config button, and then
click Write Config button to save the
wifi settings into panel’s ROM memory.
4. Wait for the
“State” at the bottom to
change back to Ready highlighted in
green and verify
“Message” at the
bottom of the screen shows success.
Note : continue to next section for Panel
Calibration , if needed. Or if you are
ready to exit at this time, skip to
Section 4.7.9 for instructions on
Exiting iDetector software, in order
to properly sync the new changes
with Ultra UAI.