[ViZion DR+ 1417V2 Wireless Panel Installation Manual]
[Ultra 4.2.9.0]
14
Customer Support
1.800.366.5343
–
3.2.2 ViZion DR+ 1417V2 Wireless Panel in
AP Mode (Alternative method)
When the panel is in
AP mode
you will connect
to the panel’s broadcasted Wi-Fi network,
(which will be named the same as the serial
number of the panel)
, using the laptop’s internal
wireless adapter. For your internet connection,
you will connect to any available Wi-Fi network
using the external USB Wi-Fi adapter.
Equipment required for AP mode:
•
ASUS Dual-Band Wi-Fi USB Adapter
(used for the Wi-Fi Internet connection)
•
Link Cable (to preconfigure the panel’s
wireless settings)
Note
: you will configure the panel into AP
mode later in
Section 4.7.3
, once
you get to that part of the
installation.
For now, during the installation, we need the
Link cable connected to the LAN Ethernet port
the same as in
Section 3.2.1
. Once the
installation is complete, follow the steps below
to configure the
Wireless network adapter
for
use in wireless AP mode.
1. From Control Panel, select Network
Connections, and right-click on the
Intel
Wireless adapter
and select
Properties
.
2. Select
Internet Protocol Version 4
(TCP/IPv4)
and click
Properties
.
3. Select
Use the following IP address
radio button.
4. Enter the following settings:
•
IP address
192.168.8.188
•
Subnet mask
255.255.255.0
5. Click
OK
to save the changes.
6. But during the installation, we need to
have the Link cable connected, so follow
the steps in
Section 3.2.1
for now.
7. Connect the ethernet RJ-45 end of the
Link cable
to the
LAN Ethernet port
on
the laptop computer.
8. Connect the mini-HDMI end of the
Link
cable
to the
Link port
on the side of the
panel.
9. Plug in the
ASUS Dual-Band Wi-Fi
USB Adapter
and wait for the drivers to
install. This adapter will be used to
connect to Wi-Fi networks for your
internet connection. Driver software
should install automatically or from CD.
10. Proceed to
Section 4
.