[ViZion DR+ 1417V2 Wireless Panel Installation Manual]
[Ultra 4.2.9.0]
12
Customer Support
1.800.366.5343
–
3.1.1 Configure IP Address on the PC
1. From Control Panel, select Network
Connections, and right-click on the CT
network adapter and select
Properties
.
2. Select
Internet Protocol Version 4
(TCP/IPv4)
and click
Properties
.
3. Select
Use the following IP address
radio button.
4. Enter the following settings:
•
IP address
192.168.8.188
•
Subnet mask
255.255.255.0
5. Click
OK
to save the changes.
6. Connect the ethernet RJ-45 end of the
Link cable
to one of the
Yellow ports
on the ASUS Access Point.
7. Connect the mini-HDMI end of the
Link
cable
to the
Link port
on the side of the
panel.
8. Proceed to
Section 4
.
3.2 Mobile Network Configuration
For mobile environments, the panel can be put
into
Client mode
(to connect the laptop to an
external access point device, that the panel will
connect to [recommended method]), or put in
AP mode
(to allow the panel to broadcast a
wireless network, for the laptop to connect to
[alternative method).
3.2.1 ViZion DR+ 1417V2 Wireless Panel in
Client Mode (Recommended method)
When the panel is in
Client mode
, the panel
will connect automatically to the external TP-
Link Access Point
, using the laptop’s LAN
Ethernet adapter. For your internet connection,
you will connect to any available Wi-Fi network
using the
laptop’s internal wireless adapter.
Equipment required for Client mode:
•
TP-Link AC750 Wireless Travel Router
Access Point
•
Link Cable (to preconfigure the panel
’s
wireless settings)
Note
: you will configure the panel into
Client mode later in
Section 4.7.2
,
once you get to that part of the
installation.
For now, we will configure the
LAN Ethernet
network adapter
(without the TP-link AP
connected), so the panel communicates wired
via the
Link cable
during the installation.