Konica Minolta T-10A, Инструкция по эксплуатации

Страница: 26 / 60

24
11
The unit will blink, indicating that measurement is currently
paused.
z
This also occurs in normal and
⊿
modes.
12
Set the power switch to “O” (OFF).
z
If the power switch is not set to “O” (OFF) to reset the instrument,
it will also be impossible to perform measurement in other modes.
Checking the Setting
z
To check the currently set value, press the [
CALL
] key. The currently set value will be displayed while
the [
CALL
] key is held down.
Changing the Setting
If you want to change the currently set value while measurement is in progress, carry out
steps 4 to 9.
z
The value you are going to set must be larger than the currently set value. If a value smaller than
currently set value is set, “Err A” will appear, causing the SET mode to be exited.