Konica Minolta T-10A, Инструкция по эксплуатации

Страница: 13 / 60

11
1
Set the power switch to “O” (OFF), and pull the battery cover
as shown while pressing it down slightly.
z
Have two AA-size batteries ready.
2
Install the batteries in the correct direction, then put the
cover on.
Turning Power ON
1
Set the power switch to “I” (ON).
z
Setting the power switch to “I” (ON) with the hold button
pushed out (RUN) will start measurement immediately.
z
Setting the power switch to “I” (ON) with the hold button pushed
in (HOLD) will not start measurement. To start measurement,
the hold button needs to be pushed out (RUN).
Installing the Batteries
WARNING
Do not allow batteries to come into contact with fire, and do not charge them (unless they
are specifically designated as rechargeable), heat them, or take them apart. Any of these
actions may cause batteries to overheat or explode, possibly resulting in fire or injury.
CAUTION
Do not use battery types that are not specified for this instrument. Never mix old and new
batteries, or different types of batteries. Be sure to load batteries with the (+) and (–) polarities
in the correct direction. Neglecting any of these precautions may result in battery leakage or
explosion, possibly resulting in fire, injury, or environmental damage.