Konica Minolta T-10A, Инструкция по эксплуатации

Страница: 45 / 60

43
7
Set the power switch to “I” (ON).
‹ The smallest ID no. among those currently set will be
displayed at the upper right of the display section.
z
Press the [
▲
] or [
▼
] keys to check that the ID no.
switches from one to another. Make sure that the ID nos. of all the
connected receptor heads are displayed one at a time (they are
displayed in the ascending order: starting from the smallest ID no.).
z
If they are not displayed, check connection between the
main body and receptor heads as well as the ID nos.
* In the above example, the [
▲
] key is pressed to change the display. The
display will change in opposite direction if the [
▼
] key is pressed.
8
Push out the hold button (RUN).
‹ Measurement will start, and the value measured by one of
the receptor heads or the average value of those measured
by the connected receptor heads will be displayed.
z
Measured values are displayed in the order of ID nos.
z
Each time the [
▲
] or [
▼
] key is pressed, the measured
value will switch from one receptor head to another.
* In the above example, the [
▲
] key is pressed to change the display. The
display will change in opposite direction if the [
▼
] key is pressed.
* If a large number of receptor heads are connected, the display will not switch from MULTI AVG
immediately even if the [
▲
] (or [
▼
] ) key is pressed. In this case, keep holding down the [
▲
] (or [
▼
] ) key.
→
MULTI 1
↓
MULTI 2
↓
MULTI 3
↓
…
↓
MULTI AVG
Average value of those measured by all the connected receptor heads
MULTI 1
↓
MULTI 2
↓
MULTI 3
↓
…
↓
MULTI AVG
Average value of those measured by all the connected receptor heads
→