Konica Minolta CM-23d, Инструкция по эксплуатации

Страница: 79 / 151

76 75
Measur
ement
2
„ Parametric Coefficient Setting
Memo
The parametric coefficient is set to “1.00” when the instrument is shipped from the factory.
Operating Procedure Start the procedure from the <Setting> - <Default data setup> screen.
1
Use [
▲
] or [
▼
] to move the cursor to “Parametric
coef.”, and then press the [Confirmation] key.
The <Parametric coef.> screen
is displayed.
2
Use [
▲
] or [
▼
] to move the cursor to the item to be
set, and then press the [Confirmation] key.
The <Parametric coef.> edit screen is displayed.
3
Use [
▲
] or [
▼
] to move the cursor to the item to set,
and press the [Confirmation] key to change the setting.
• Pressing the [Confirmation] key causes the cursor to
appear on the value. Press
[
▲
] or [
▼
]
to change the
value. Move the cursor between the digits of the value
by pressing
[
◀
] or [
▶
]
.
Settings
{ 0.01 to 9.99
• Press the [Confirmation] key to confirm every time the
setting of an item is changed.
4
After all settings have been configured, use [
▲
] or
[
▼
] to move the cursor to “OK”, and then press the
[Confirmation] key.
The setting is confirmed and the screen returns to the
<Parametric coef.> screen .
Memo
If SCI+SCE is set for “Specular Component” under
<Measurement setup>, use [
◀
] or [
▶
] to switch between
SCI and SCE.
Notes
If [ESC] is pressed during setup, the settings will not be
changed and the screen will return to the <Parametric coef.>
screen.
5
Press [ESC] to return to the <Default data setup>
screen.