Konica Minolta bizhub PRESS 1052, Руководство пользователя

Страница: 74 / 540

bizhub PRESS 1250/1052 2-60
2.5 Using Machine When Power Save LED Lights 2
2.5.5 Limiting Machine Usage: Weekly Timer
Weekly Timer turns a machine on and off at the time specified by the administrator.
When a machine is in OFF condition under control of Weekly Timer, the Power Save LED is lit and machine
operation is unavailable.
d
Reference
Weekly Timer settings are provided on the Utility Menu Screen. For details, see Section 7 of the POD Admin-
istrator's Reference.
To use the machine temporarily
The following procedure temporarily enables the machine operation. (Timer Interrupt)
1
Press Power Save on the control panel .
The Machine Screen will be displayed along with the message shown below.
[Timer interrupt mode / Please enter password ****]
%
If the message [Please specify desired copy time / 0 hour(s) 05 minute(s)] is displayed, proceed to
step 3.
%
The machine power will be turned off automatically after 5 minutes from this state without any op-
eration made.
2
Enter the Timer Interrupt password, then press Start on the control panel .
Enter a 4-digit Timer Interrupt password using the control panel keypad , then press Start .
[Timer interrupt mode / Please enter password ****]
%
The Timer Interrupt password (Password Non-Business Hours) is specified in the Administrator Set-
ting on the Utility menu. Ask your administrator for the specified Timer Interrupt password.
%
If an invalid password is entered, continue by entering the valid 4-digit password.
3
Set the hour for the interrupt use, then press Start on the control panel .
Enter a 1-digit hour (from 0 to 9) using the control panel keypad , then press Start .
[Please specify desired copy time / 3 hour(s) 05 minute(s)]
4
Set the minute for the interruption use, then press Start on the control panel .
Enter a 2-digit minute (from 0 to 59) using the control panel keypad , then press Start .
[Please specify desired copy time / 3 hour(s) 30 minute(s)]
Machine operation is now available with the message [Ready to print] displayed on the screen, until the
set time is up.
%
To specify a 1-digit minute, enter [0] first to make it two digits. However, you cannot specify the time
shorter than 5 minutes. Entering 0 for hour and a number smaller than 5 for minute will set the minute
at 5. Also, a number larger than 60 is unavailable for minute.
5
When the machine operation is finished within the set period of time, hold down Power Save on the
control panel for over a second.
The machine returns to OFF condition.