Konica Minolta 7115F, Инструкция по эксплуатации

Страница: 289 / 327

Error Messages 12
Konica 7115F/7118F 12-19
SET ORIGINAL TO ADF A document was not loaded
into the Automatic Document
Feeder before beginning a
copy function (such as,
“2 in 1” copying or “Mixed
Orig.” copying) that uses the
Automatic Document Feeder.
Otherwise, the Automatic
Document Feeder is lifted up. Load a document into the
Automatic Document Feeder.
Securely close the Automatic
Document Feeder.
REMOVE PAPER When interrupting a copy job
to perform a different copy
operation other than the
“Dual Page” function, the
document for the interrupted
copy job was left in the
Automatic Document Feeder. Remove the document from
the Automatic Document
Feeder.
TEXT
×
1.0 1
ä
[A]
ü
#XXX:EMPTY
(While specifying copy
settings)
The selected paper tray has
run out of paper.
“#” indicates the paper tray,
and “XXX” indicates the
paper size. Either load paper of the
specified size into the
specified paper tray, or press
the [PAPER SIZE] key and
select a different paper size.
NO SUITABLE PAPER • While copying, the size of
the paper in the selected
paper tray has changed.
• While copying documents
with mixed sizes using the
“APS” function, paper of a
suitable size could not be
found.
“#” indicates the paper
tray, and “XXX” indicates
the paper size.
Either load paper of the
specified size, or press the
[PAPER SIZE] key and select
a different paper size.
(Flashing alternately)
LOAD PAPER (#XXX)
APS SIZE ERROR While copying using the
“APS” function, paper of a
suitable size could not be
found. Either load paper of a
suitable size, or press the
[PAPER SIZE] key and select
a different paper size.
AMS SIZE ERROR While copying using the
“AMS” function, the
combination of the document
and paper sizes caused the
zoom ratio to exceed the
range between
×
0.5 and
×
2.0.
Either load paper of a
suitable size, or use the [
]
and [ ] keys to specify the
zoom ratio.
PAPER SIZE ERROR The paper loaded in the
paper tray caused a size
error.
“#” indicates the paper tray,
and “XXX” indicates the
paper size. Pull open the paper tray with
the size error, and then close
it again.
Check if a custom paper size
has been entered, and
correct the paper size using
the appropriate Initial Set
mode function.
(Flashing alternately)
RESET PAPER (#XXX)
Message Cause Remedy