Kongsberg Simrad EK80, Руководство по установке

Страница: 261 / 354

394149/D
259
b Allow the data recording to run approximately five minutes.
c Stop raw data recording.
d Use a file manager, and verify that the recorded file(s) have been saved on
the chosen disk.
e Verify that the playback is operational.
14 Select
Help
on the top bar.
a Make sure that the online help opens on its start page.
b Close the online help.
Result
Requirements Results
The latest software version is installed.
Each transducer is installed with the correct parameters.
Each transceiver channel is operational.
The EK80 detects and displays a bottom echo in each echogram.
Date and signature:
Related topics
Test procedures, page 256
Measuring noise in passive operating mode
Low noise is a key factor for high quality and reliable measurements. The performance
of the EK80 will always be limited by different noise sources. The noise is measured
while the EK80 operates in
Passive mode with the transmit pulses disabled.
Prerequisites
The EK80 hardware units are installed as specified in this manual.
• The EK80 system is turned on and operates normally.
Caution
You must never set the EK80 to "ping" unless the transducer is submerged in water.
The transducer may be damaged if it transmits in open air.
• All the relevant transceivers have been set up, and they are operational with their
respective transducers.
• All relevant channels (transceiver/transducer combinations) are installed in the user
interface.
• All relevant external sensors are connected to the EK80. The sensors are turned
on and operate normally.
Setting to work