Kohler KGP, Руководство пользователя

Страница: 109 / 126

TP-6461 1/08
109
Section 7 Component Replacement, Model KSP
Spring-loaded parts.
Can cause severe personal injury
or property damage.
Wear protective goggles when
servicing spring-loaded parts. Hold
parts securely during disassembly.
WARNING
3. The closing coil is spring-loaded. Hold the closing
coil securely and remove four M8 bolts. Remove
the closing coil. See Figure 7-30.
6226
1. M8 bolts
2. Nut, movable steel shaft
1 2
Figure 7-30 Closing Coil Bolts and Nut
4. Replace the closing coil.
a. Reuse the spring from the original coil.
b. Align the boss on the coil into the recess in the
frame.
c. Replace the four M8 bolts. See Figure 7-30.
d. Reconnect four leads shown in Figure 7-29.
5. Adjust the movable steel shaft as described in the
following procedure.
7.3.2 Shaft Adjustment,
600 Amp Models
Note: It is not necessary to remove the movable steel
shaft when replacing the closing coil.
1. Turn the large round shaft in (clockwise) until the
mechanism just latches when operated with the
manual handle. If turned too far, it won’t latch.
2. Turn the shaft back 1.5 rotations from the limit of
the switching range.
3. Hold the shaft and tighten the nut.
4. Replace the cover on the mechanical unit.
7.3.3 Auxiliary Switch Replacement,
600 Amp Models
Loosen the M4 bolts and replace the auxiliary switches.
Tighten the mounting screws to 0.14 Nm (1 in. lb.),
maximum. See Figure 7-31.
6226
1. Auxiliary switches
2. M4 bolts
2 1
Figure 7-31 Auxiliary Switches, 600 Amp Models