23-5
Error messages & Troubleshooting
Troubleshooting
TROUBLESHOOTING
Problem
Solution
Page
General problems
Power does not turn on
Make sure that (1) the power cord is plugged into the outlet, (2) the cable is plugged into
the connector on the back of the instrument, (3) and is not damaged, (4) there are no
problems with the mains.
Is the power switch turned ON?
If the power still does not turn on, contact your KOHLER dealer.
No sound
Is a jack connected to the HEADPHONES connector? This would disable the internal
speakers.
1
Check the connections of your amp or mixer (if external amplofication is used).
1
Make sure that all the components of the amplifier system are turned on (if external
amplofication is used).
Is the MASTER VOLUME slider of the KD set to a position other than “0”?
1
Is the Local parameter set to Off? Turn it On.
4
Is the Speaker parameter set to Off? Turn it On.
2
Is the Attack parameter value too high? Set it to a lower value, to let the sound start
faster. Is the Volume parameter too low? Set it to a higher value.
5
8
Lowest note are not played
When the SPLIT button is lit up, the keyboard will be divided into the Lower part (low
notes, below the split point) and the Upper part (high notes, above the split point). Is the
Lower track muted? Unmute it.
1
Wrong sounds
Do the USER banks contain modified data? Load the appropriate data for the Song or the
Style you wish to playback.
6
Has one of the USER Drum Kits been modified? Load the appropriate Drum Kits.
6
Have the Styles or Performances been modified? Load the appropriate data (Styles or Per-
formances).
6
Sound does not stop
Make sure that the damper switch polarity parameter is set correctly.
3
The selected Style or Song can-
not start
Make sure that the Clock parameter is set to Int. If you are using the MIDI Clock of
another device, you must set the MIDI Clock parameter to MIDI or PC TO HOST (depend-
ing on the port the KD is hooked to the other device through) and make sure that the
external device transmits MIDI Clock data.
4
Does not respond to MIDI mes-
sages
Make sure that all MIDI cables are connected correctly.
1
Make sure that the external device is transmitting through MIDI channels enabled to
receive in the KD.
9
10
Make sure that the MIDI IN Filters of the KD do not prevent the reception of messages.
5
Percussive instruments are not
played correctly
Make sure that the Percussion and Drum Track is set to Drum Mode and the
external device has not transposition applied.
9
10
Some “clicks” can be heard
when playing a percussive
instrument
This is part of the sound, and not a problem.
A background noise can be
heard after selecting a Perfor-
mance, Style or STS
The selected Performance, Style or STS recalled the effect “15 Analog Record”, simulating
the noise of a old vinyl recording.
Содержание KD-150
