![Kohler KD-150 Скачать руководство пользователя страница 230](http://html.mh-extra.com/html/kohler/kd-150/kd-150_owners-manual_1988893230.webp)
18-5
Effects
Filter/Dynamic
The Attack and Release parameters set the Gate attack
time and release time.
e: Delay Time
This parameter sets the delay time of the Gate input. If
the sound has a very fast attack, increase the delay time so
that the signal will be input after the Gate is opened. This
will preserve the attack part of the sound.
006: OD/HGainWah
(Overdrive/Hi.Gain Wah)
This distortion effect utilizes an Overdrive mode and a Hi-
Gain mode. Controlling the wah effect, the 3-band EQ, and
the amp simulation will allow you to create versatile distor-
tion sounds. This effect is suitable for guitar and organ
sounds.
a: Wah
The Wah parameter switches the wah effect on/off.
a: Sw
This parameter sets how the wah effect is switched on and
off via the modulation source.
When “Sw” =
Moment
, the wah effect is usually turned
off. It is turned on only when you press the pedal or oper-
ate the joystick.
When a value for the modulation source is less than 64, “off”
speed is selected, and when the value is 64 or higher, “on” is
selected.
When “Sw” =
Toggle
, the wah effect is switched between
on and off each time you press the pedal or operate the
joystick.
The switch will be turned on/off each time the value of the
modulation source exceeds 64.
b: Wah Sweep Range, b: Wah Sweep Src
This parameter sets the sweep range of the wah center
frequency. A negative value will reverse the direction of
sweep. The wah center frequency can be controlled by the
modulation source specified in the “Wah Sweep Src”
parameter.
d: Drive, e: Output Level
The degree of distortion is determined by the level of
input signal and the setting of “Drive”. Raising the
“Drive” setting will cause the entire volume level to
increase. Use the “Output Level” parameter to adjust the
volume level. The “Output Level” parameter uses the sig-
a
Wah
Switches Wah on/off
Off, On
☞
,
Src
Off...Tempo
Selects the modulation source that switches the Wah on and off
Sw
Toggle, Moment
Selects the switching mode for the modulation source that switches the Wah
on and off
☞
b
Wah Sweep Range
Sets the range of Wah
–10...+10
☞
,
Wah Sweep Src
Off...Tempo
Selects the modulation source that controls the Wah
☞
c
Drive Mode
Overdrive, Hi-Gain
Switches between overdrive and hi-gain distortion
d
Drive
Sets the degree of distortion
1...100
☞
Pre Low-cut
0...10
Sets the low range cut amount of the distortion input
☞
Input Level
Output Level
Threshold
Louder
Louder
Threshold
Attack=1
Release=1
Attack=100
Release=100
Dry
Wet
Wet
Attack
Release
Gate - Attack / Release
Gate - Threshold
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
Amp Simulation
3 Band PEQ
Output Level
Direct Mix
Pre Low-cut
D
-mod
Wah
Mode: Overdrive / Hi-Gain
Drive
Driver
e
Output Level
Sets the output level
0...50
☞
,
Src
Selects the modulation source for the output level
Off...Tempo
Amt
Sets the modulation amount of the output level
–50...+50
f
Low Cutoff [Hz]
20...1.0kHz
Sets the center frequency for Low EQ (shelving type)
Gain [dB]
Table , “Sets the gain of Low EQ,” on page 2
–18...+18dB
g
Mid1 Cutoff [Hz]
300...10.00kHz
Sets the center frequency for Mid/High EQ 1 (peaking type)
Q
Sets the band width of Mid/High EQ 1
0.5...10.0
☞
Gain [dB]
Sets the gain of Mid/High EQ 1
–18...+18dB
h
Mid2 Cutoff [Hz]
500...20.00kHz
Sets the center frequency for Mid/High EQ 2 (peaking type)
Q
Sets the band width of Mid/High EQ 2
0.5...10.0
☞
Gain [dB]
Sets the gain of Mid/High EQ 2
–18...+18dB
i
Direct Mix
0...50
Sets the amount of the dry sound mixed to the distortion
Speaker Simulation
Switches the speaker simulation on/off
Off, On
j
Wet/Dry
Dry, 1:99...99:1, Wet
Table , “Sets the balance between the effect and dry sounds,” on page 1
Src
Off...Tempo
Table , “Selects the modulation source of the effect balance,” on page 1
Amt
Table , “Sets the modulation amount of the effect bal-
ance,” on page 1
–100...+100
Содержание KD-150
