Koden MDC-2000 series, Руководство по эксплуатации

Страница: 32 / 82

MDC-2000 Series Chapter 2 How to use the menu
0093120005-02 2-6
Note on PPI/PPI Display
In the PPI/PPI display, to avoid risk, the following
functions do not work.
● TM (True Motion)
● Off center
● Trailing
● ATA (Optional)
The EBL, VRM and PI (parallel cursor) can be
displayed only in the main screen.
PPI/NAV Display
The radar image is displayed in the upper half of
the screen and the navigation data is displayed
in the lower half of the screen.
The content of the navigation data display can be
selected.
For the NAV Display Select, refer to [NAV
Display Select] in 3.5 Preset.
Note on PPI/NAV Display
In the PPI/NAV display, to avoid risk, the
following functions do not work.
● TM (True Motion)
● Off Center
2.5 Setting of OFF CENTER
When viewing widely in the heading, use this
function.
Setup: OFF, ON (Initial value: OFF)
1 Press the [MENU] key
2 Select [ECHO] → [OFF CENTER].
3 Change the setting of [OFF CENTER] to
[ON] with the [ ] and [ ] keys.
It moves to the off center position where the
own ship point is stored
OFF CENTER
OFF
ON
4
Press the [ ] key.
5
Move the crosshair cursor to the point you
desire to move your ship with the [ ], [ ],
[ ] [ ] keys.
6
Press the [ENT] key.
Own ship’s position moves to the position of
the crosshair cursor.
7
Press the [MENU] key to close the menu.
● The movable range is limited.
(See the movable range shown below.)
34%
66%
Own ship
relocatable
area
Own ship
● When [PPI/PPI] or [PPI/NAV] is selected in
[DISPLAY SELECT], the off-center cannot be
executed.
2.6 Setting of Enhance
(Enlarged Target)
If a target is too small to see, the target can be
enlarged to make it easier to see it.
Setup: OFF, 1, 2 (Initial value: OFF)
1 Press the [MENU] key
2 Select [ECHO] → [ENHANCE].
3 Change the setting of [ENHANCE] with the
[ ] and [ ] keys.
The greater the numeral is, the larger the
target is enlarged.
4 Press the [MENU] key to close the menu.
2.7 Setting of Signal Process
If the reflection from a target you desire to see is
unstable, the target is stabilized by rendering the
signal process.
Setup: OFF, ON (Initial value: OFF)
1
Press the [MENU] key,
2
Select [ECHO] → [PROCESS].
3
Change the setting of [PROCESS] with the
[ ] and [ ] keys.
4
Press the [MENU] to close the menu.