Koden MDC-2000 series, Руководство по эксплуатации

Страница: 22 / 82

MDC-2000 Series Chapter 1 Basic Operation
0093120005-02 1-6
1.3 Power On/Off
The [ ] key is used for both the power on/off
and the change of brilliance of the LCD & panel.
Power On
1
Press the [ ] key to turn on the power.
The start-up menu is displayed. During the
display of start-up menu, the memory is
automatically checked. If the check result is
correct, the radar image appears,and start
count down time for magnetron preheat.
Power Off
1
When turning off the power, keep pressing
the [
] key until display [Turns off
power].
Language Selection at Initial Start-up
When turning on the power for the first time after
[ALL RESET], the [LANGUAGE] menu appears.
2
Select the language with [ ] and [ ] keys.
During display of [LANGUAGE] menu,
pressing the [ ] key will return to the initial
setup menu.
Pressing the [ ] key will redisplay the
[LANGUAGE] menu.
3 Press the [MENU] key to set the language.
1.4 Brilliance Adjustment
Brightness Adjustment of LCD
The brilliance of menu can be adjusted to make it
easier to see.
Setup: (1 to 10) (Initial value: 10)
1
Press the [ ] key briefly.
2
Press the [ ] and [ ] keys.
“1” is the darkest. “10” is the brightest.
LCD BRILL
10
3 Press the [MENU] key or [ENT] key to close
the menu.
Brightness Adjustment of Panel
The panel brightness can be adjusted,
Setup: (1 to 10) (Initial value: 10)
1
Press the [ ] key briefly.
When [LCD BRILL] appears, press the
[ ] key again.
2
Select the level with the [ ] and [ ] keys.
“1” is the darkest. “10” is the brightest.
PANEL BRILL
10
3 Press the [MENU] key or [ENT] key to close
the menu.
1.5 Transmission
Start of Transmission
After turning on the power, remaining time of
pre-heat is displayed in the center of the screen.
After 120 seconds, ST’BY appears in the center
of the screen and the unit becomes “STBY” state.
On the “STBY” state, when the [STBY/TX] key is
pressed, the unit starts the transmission.
Stop of Transmission
On the “TX” state, when the [STBY/TX] key is
pressed, the unit stops the transmission and
returns to the “STBY” mode.
Re-entry of power shall be performed
after having passed for longer than 3
seconds after power-off.
Caution
BRILL
BRILL
BRILL
BRILL
BRILL
BRILL