Kodak Instamatic M Series, Ремонт

Страница: 25 / 56

23/KODAK M-SERIES PROJECTORS
Locate the groove around the outer circumference of the
shoulder at the center of the in-and-out cam, Fig. D75. Using
the single-edge razor blade, cut off the front section of the
shoulder—from the end to the groove, Fig. D76.
Even though you've cut off the front of the shoulder, there's
still a raised section at the center of the in-and-out cam—the
section from the groove to the surface of the in-and-out cam.
But you compensated for this difference when you modified
the bushing.
Install the modified bushing to the lever assembly as shown
in Fig. D72 and Fig. D73. The shoulder passes through the
lever assembly from the back, Fig. D73.
Before replacing the lever assembly, clean the front surface
of the in-and-out cam, Fig. D75, using the AK225 cleaner.
Lubricate the front surface of the in-and-out cam with the
Super Lube grease. Then seat the lever assembly on the in-
and-out cam, Fig. D69. Replace the washer and the E-clip.
INSTALLING AND TIMING THE DRIVE-CAM
ASSEMBLY
It's now time to replace the drive-cam assembly in the
mechanism. The shutter and shutter-drive shaft have already
been installed. As you install the drive-cam assembly, you'll
time the in-and-out cam to the shutter. The claw then moves
the film while the shutter is closed—and holds the film in
place while the shutter is open.
First locate the brass post on the lever assembly, Fig. D77—
the lip on the brass post must slip into the keyed slot shown
in Fig. D78 and D79. Also note the plastic piece around the
brass post, Fig. D77. You may find that the plastic has
broken. Or the plastic piece may be completely missing as in
Fig. D78. Fortunately, the
projector will work properly
without the plastic piece.
Slide the drive-cam assembly
into the mechanism as shown in
Fig. D80. Note the alignment of
the brass post on the lever
assembly shown also in the
close-up photos. Also make sure
the slot in the tab on the film-
selector slide, Fig. D80, fits over
the black arm of the super-8/
regular-8 mask.
Fully seat the drive-cam
assembly. But before you tighten
the spring clamps on the cam
shaft, we'll time the in-and-out
cam to the shutter.
TAB
FIG. D80 Installing the drive-cam assembly.
POST ON
LEVER
ASSEMBLY
PLASTIC
PIECE
FIG. D77 End of the lever assembly.
FIG. D78
Starting
the lever
assembly
into
position.
FIG. D79
The post on
the lever
assembly
within the
slot.
Compliments of:
www.KodakParts.com