Kodak Instamatic M Series, Ремонт

Страница: 32 / 56

30/KODAK M-SERIES PROJECTORS
TAKE-UP SPINDLE
SUPPLY SPINDLE
WIRE CLIP
SPINDLE
9. Replace the motor and fan assembly, Fig. D105. Again,
use shutter oil on the screws, Fig. D102, to prevent the
grommets from turning. Connect the rubber belt, Fig. D105,
between the fan pulley and the pulley on the shutter-drive
shaft.
S HUTTER CHECK: Pull the rubber belt on the fan
pulley slowly toward you. The rubber belt turns the
shutter. Check carefully to make sure the shutter does not
touch any part of the projector through its 360° rotation. If
the clearance isn't sufficient at any point in the rotation, you
may have to slightly bend the shutter
9. Turn the fan housing, Fig. D105, to the position shown in
Fig. D106. Then bend down the metal tab, Fig. D105, as
shown in Fig. D106.
10. Route the white and black motor wires as shown in Fig.
D106. Replace the wire clip, Fig. D106.
11. Gather the wires coming from the motor and from the
wirewound resistor. Connect the upper wire clip, Fig. D106,
to hold the wires.
12. Install the forward/reverse arm, Fig. D106. Turn the
eccentric to your scribed position before you tighten the
screw. Replace the spring for the forward/reverse arm.
Remember the spring-hooking point—the metal tab over the
fan cover if the projector uses the short spring, the spring
hooking tab if the projector uses the long spring. Fig. D106
shows the long spring connected to the spring-hooking tab.
To check the adjustment on the forward/reverse-arm eccen-
tric, see,
Adjustments #1. In fact, before connecting the
power cord to the projector, it's a good practice to check both
the forward/reverse-arm adjustment and the adjustment on
the still-mask changeover rod. See
Tests and Adjustments, #1
and #2.
We'll now connect the power cord to the projector so we can
make the tests and adjustments. Remember, never plug the
power cord to a wall outlet until you've replaced the bottom
cover.
Both leads of the power cord are black. Route the long lead
as shown in Fig. D106—through the clamp to the switch.
Insert the bare end of the wire lead into the "L" port of the
switch.
Hold the short lead of the power cord against the red lead
that comes from the lamp socket. The bare ends of the black
lead and the red lead should be even with one another. Then
install the wire tie, Fig. D106, over the bare ends of the
leads. Turn the wire tie in a clockwise direction to twist and
hold the wires.
Check the routing of the wires coming from the switch in
Fig. D106.
Route the wires as shown; the routing pre-
vents the wires from being pinched by the bottom cover.
FIG. D107 Side of spindle with the spindle
pulled slightly from the projector.
FIG. D108 Front of projector.
FIG. D109 Bottom of spindles.
FIG. D110 Here's the typical rewind problem—
the tabs are broken off the rewind driver.
REWIND DRIVER
TAKE-UP SPINDLE
SUPPLY SPINDLE
FAST-REWIND KNOB
COVER PLATE
LOOSEN SCREW
BROKEN
TABS
Compliments of:
www.KodakParts.com