Kodak Instamatic M Series, Ремонт

Страница: 29 / 56

27/KODAK M-SERIES PROJECTORS
TAB
STILL-MASK
CHANGEOVER
ROD
STILL-FRAME
LEVER
SPRING TAB
ON SPEED-
LEVER
ASSEMBLY
Fig. D94 shows how the torsion-type spring should be
connected. Grasp the long (loose) end of the spring. Turn the
long end of the spring in a clockwise direction until you can
hook it against the tab (to the left of the tab in Fig. D94).
With all repairs completed on the mechanism, you're now
ready to replace the mechanism in the housing.
COMPLETING REASSEMBLY OF THE
MECHANISM
1. Replace the still-mask changeover rod, Fig. D95. The still-
mask changeover rod passes through the hole in the still-
frame lever and through the slot in the spring tab of the
speed lever. Replace the snap ring over the end of the still-
mask changeover rod, Fig. D97. Remember, the position of
the snap ring provides an adjustment. You noted the position
prior to removing the snap ring. In most cases, the snap ring
is around 1/4" from the end of the still-mask changeover rod,
Fig. D97. Replace the spring for the still-mask changeover
rod, Fig. D95.
SPRING
SNAP RING
APPROXIMATELY 1/4"
FIG. D94 Underside of damping-arm
assembly.
FIG. D96 Variation in the latching mechanism
for the damping arm. Here the spring does not
disconnect when you remove the damping
arm.
FIG. D95 Still-frame
changeover rod installed in the
mechanism.
FIG. D97 Initial adjustment of snap ring
position on still-frame changeover rod.
SPRING
Compliments of:
www.KodakParts.com